Practical Considerations for Plastic Granulators

In reality, many friends do not have a good grasp of the knowledge of machine operation, so many times the failure of machinery and equipment is caused by misoperation. Therefore, plastic machinery and equipment (including plastic granulator, single-screw granulator, etc.) , waste plastic granulator, etc.) The correct actual operation can be used to prolong its life. However, the application of plastic machinery and equipment has not been paid enough attention in our daily life, and it will also cause some unnecessary problems. What problems should we pay attention to when applying plastic machinery and equipment?

1. Pay attention to fire safety. Fire extinguishers should be placed around the equipment where heat transfer oil is applied.

2. When there is a fault or abnormal situation, it must be reported to the relevant staff, and the staff of the maintenance center will carry out the solution. If you find that there are abnormal problems that endanger safety, press the emergency stop switch immediately.

3. It is not necessary to use low-quality recycled materials with metal material residues or fine sand, and metal objects that will fall into the vicinity of the feed port should not be placed to prevent aggravating the damage of the extruder screw and barrel or causing jamming and destruction. question.

4. The actual operation of plastic machinery and equipment should use gear oil whose cleanliness, viscosity and other indicators meet the regulations, and provide cooling circulating water with sufficient total flow for the water cooler in accordance with the regulations to prevent hydraulic parts and pipes from being polluted by the compressor lubricating oil environment. Or high temperature causes blockage, oil leakage and other damage problems. The extruder should fill the reducer with lubricating oil that meets the regulations.

5. The actual operation of plastic machinery and equipment must be strictly in accordance with the requirements of the operating procedures, and no illegal acts shall be carried out in the non-operating station. To ensure the reliability of the safety device, the safety protection measures of the machine shall not be destroyed for the pursuit of efficiency.

6. During the actual operation of plastic machinery and equipment, if the temperature of the material does not reach the set temperature, and the holding time is not enough, it is not allowed to start the extruder screw.

7. Practical operations are carried out by operators who are trained and familiar with the structural performance and operating procedures of plastic machinery and equipment.

Mastering the above seven precautions can greatly reduce the mechanical failure and damage of mechanical equipment caused by wrong operation, and greatly prolong the service life and reliability of mechanical equipment! And in the long run, the correct way of operating the machine is an important part that does not need to be questioned!

HLJX PLASTIC Machinery Co., Ltd. is a Plastic machinery Manufacturer and Mold Temperature Controller and other products. Welcome to our official website.