Practical Precautions for Plastic Granulator and Plastic Machinery!

In reality, many friends do not have a good grasp of the knowledge of machine operation, so many times they cause mechanical failures due to misoperation. Therefore, plastic machinery (including plastic granulators, single-screw granulators, waste The correct operation of plastic granulator, etc.) can be used to prolong its life. However, the use of plastic machinery has not been paid enough attention in our daily life, and it will also cause some unnecessary problems. Then we are using plastic What should be paid attention to when mechanically?

1. Pay attention to fire safety. The fire extinguisher should be placed near the equipment that uses heat transfer oil.

2. In case of failure or abnormal situation, it must be reported to the relevant personnel and handled by professional maintenance personnel. If an abnormal phenomenon affecting safety is found, press the emergency stop switch immediately.

3. Do not use low-quality return materials with metal impurities or sediment, and do not place metal objects that may fall near the feeding port to prevent aggravating the wear of the screw and barrel or causing jamming and damage.

4. The operation of plastic machinery should use hydraulic oil that meets the requirements of cleanliness, viscosity and other indicators, and provide cooling water with sufficient flow to the oil cooler according to regulations, so as to prevent hydraulic components and pipelines from being blocked and leaking due to oil pollution or high temperature. etc. damage. The extruder should fill the reducer with lubricating oil that meets the requirements.

5. The operation of plastic machinery must be strictly in accordance with the requirements of the operating procedures, and no illegal operation shall be carried out in the non-operating station. To ensure the reliability of the safety device, the safety protection measures of the machine shall not be destroyed for the pursuit of efficiency.

6. When the plastic machinery is operating, if the material temperature does not reach the set temperature, and the holding time is not enough, it is not allowed to start the screw.

7. Operate by trained operators who are familiar with plastic mechanical structure performance and operating procedures.

Mastering the above seven precautions can greatly reduce the mechanical failure and mechanical damage caused by wrong operation of the machine, and greatly prolong the service life and stability of the machine! And in the long run, the correct way of operating the machine is an important part that does not need to be questioned!

HLJX PLASTIC Machinery Co., Ltd. is a Plastic machinery Manufacturer with a variety of products such as Low speed granulators, welcome to visit our official website.